Philips LPC2100 Blinky IRQ Example

This project is a simple program for the LPC2114 using Keil MCB2100 Microcontroller Board.

It constantly changes the status on the output port GPIO P1.16-P1.23.

The example shows:

• how to setup the Vector Interrupt controller,
• how to setup timer0 for timer interrupts,
• how to change the port.

The Blinky program is available in different targets:

• Simulator runs in the software simulator in uVision.
• MCB2100 RAM runs from the Internal RAM located on chip. This target may be used for target debugging.
• MCB2100 Flash runs from the Internal Flash located on chip. This target may be used for the final application.