Keil Logo

MON166: MONITOR WARNING, CODE_START IS EQUAL TO VECTAB


Information in this article applies to:

  • C166 All Versions

QUESTION

I'm customizing MON166 to use the Simulated Serial I/O over my target board and the following parameters are being used in config.inc, the monitor configuration file:

; Definitions of Monitor Parameters
; ---------------------------------
;
; DATA_START: Defines the Start Address for the Monitor Data Area
;             Monitor uses 512 Bytes RAM starting at this location.

   %DEFINE ( DATA_START ) ( 17E000H )     ; default Monitor data area 0x17E000 .. 0x17EFFF

; CODE_START: Defines the Start Address for the Monitor Code Area
;             Monitor requires 6KB for program code starting at this location.

   %DEFINE ( CODE_START ) ( 000000H )

; VECTAB: Defines the Interrupt Vector Address relocation
; Notes: This setting is ONLY relevant, if CODE_START is 0.  Locate interrupts
;        in your target application to the same address with µVision
;        Project-Options for Target-L166 Misc-Interrupt Vector Table Address
;        (generates the L166 VECTAB directive).

   %DEFINE ( VECTAB ) ( 100000H )         ; Address 0x100000

The simulated serial I/O works fine. When I start target debugging, I receive the following Monitor Warning message:

Monitor Warning
   Monitor Configuration seems to be wrong!
   Please check the following item of your monitor configuration:
- Monitor code address ( CODE_START) is equal to the interrupt vector address relocation ( VECTAB )

When I look at my config.inc, I see that VECTAB and CODE_START are not equal.

If they are not equal, why is this message showing up?

ANSWER

It's a typical problem when the following lines of code are missing from the inst167.a66 monitor installation file:

IF (%CODE_START = 0)
RESET_ADR      EQU     %VECTAB      ; RESET IP value
ELSE
RESET_ADR      EQU     0
ENDIF

If the above code is not in the inst167.a66 file, this warning message displays.

RESOLUTION

You may go to C166\MONITOR\ and look for inst167.a66 in any subfolder. This file contains that code.

You may also use C166\MONITOR\USER167 as a start point for your own C167 family monitor.

MORE INFORMATION

  • Getting Started and Creating Applications with µVision and 166/ST10 Microcontroller Development Tools in Chapter 11: Using Monitor-166

SEE ALSO

Last Reviewed: Friday, July 22, 2005


Did this article provide the answer you needed?
 
Yes
No
Not Sure
 
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.