C251: CREATE HEX FILES FOR CODE BANKING APPLICATIONS
Information in this article applies to:
I am using the Keil C251 toolchain to create a banked application. However, the HEX file which is created does not contain the individual banks, but instead a complete image. How can I create individual HEX files for each code bank?
Also I need to know the hardware configuration that allows me to use a common area and up to four code banks. Can you provide a circuit diagram?
The first code bank is in the HEX file at address 80:0000 the 2nd code bank on address 81:0000 and so one. This is clearly shown in the linker MAP file under MEMORY MAP OF MODULE
You may generate individual HEX files using OH251 in a batch file as shown below.
oh251 example1 hexfile (example.h00) range (0x800000-0x80FFFF) oh251 example1 hexfile (example.h01) range (0x810000-0x81FFFF) oh251 example1 hexfile (example.h02) range (0x820000-0x82FFFF)
You may run this batch file after the make command. That way, the hex files get created automatically after each build command.
Schematics for code banking hardware is provided in the LX51 User's Guide. These examples are for a generic 8051, but can be easily adapted to an 251 hardware. By using the A16 and A17 address lines as enabled (when both lines are high, the code banking is enabled in 0xFF:0000).
Last Reviewed: Friday, July 15, 2005
of your data.