ULINK: DRIVER PROBLEM GIVES NO USB DEVICE FOUND
Information in this article applies to:
I have a problem with the ULINK installation. The first time I connected the ULINK adapter, I rejected the installation of the ULINK Device Driver. Now the driver no longer tries to install. Whenever I start debugging within µVision I get the message:
NO USB DEVICE FOUND
I have got this problem also with Windows XP Service Pack 2. What can be the reason?
If you stop the installation of the USB driver, the Windows operating system no longer automatically searches for the correct USB driver.
There was also a version problem with the *.INF file which created this problems on Windows XP Service Pack 2.
To reinstall the ULINK driver proceed as described below:
Note: If you get the Windows message This hardware will not be installed. Contact your system administrator, you need to:
This completes the installation of the ULINK driver and should recover your system (sorry that this is so complex, but it is a Microsoft procedure). Whenever you connect ULINK to the USB bus all three LED will be active for about 0.5 seconds. This confirms correct initialization of the ULINK device. You should no longer have problems using ULINK from the Keil µVision3 Debugger.
Request the files attached to this knowledgebase article.
The following Discussion Forum threads may provide information related to this topic.
Last Reviewed: Friday, January 4, 2013
of your data.