Keil Logo

EPM900: LPC9102 FLASH CANNOT BE PROGRAMMED


Information in this article applies to:

EPM900 Emulator Programmer


QUESTION

When I try to load the flash of my LPC9102 in ICP (In Circuit Programming) mode, I get the following error messages in µVision:

*** LPC900 EPM Loader V1.01
*** LPC900 EPM Programmer V1.20
*** Error: This is not P89LPC9102 device.

Emulation mode works fine.

ANSWER

The EPM900 probably cannot read the Device ID when trying to initialize ICP mode. If the device signature does not read out, the most likely root cause is that the device has not properly entered ICP mode. The waveforms should match this Philips specification:

3204 Waveforms

Please make sure, that this is the case on your hardware using a scope.

MORE INFORMATION

FORUM THREADS

The following Discussion Forum threads may provide information related to this topic.

Last Reviewed: Tuesday, March 27, 2007


Did this article provide the answer you needed?
 
Yes
No
Not Sure
 
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.