Keil Logo

MON166: CONNECTING TO A TERMINAL DOESN'T WORK


Information in this article applies to:

  • C166 Version 3.12
  • C166 Version 4.03

SYMPTOMS

I have installed the MON166 monitor in ROM in my C167 hardware. However, I can't seem to connect to the monitor with my terminal. What am I doing wrong?

CAUSE

MON166 is meant to connect with the dScope debugger or the µVision debugger. A special protocol is used which is difficult to emulate with only a terminal.

RESOLUTION

Use dScope or the µVision Debugger to connect with your target hardware. The debugger will route your serial output to a window. Since the communication with the monitor uses a protocol, anything that doesn't use this protocol MUST be your serial I/O.

Last Reviewed: Wednesday, June 16, 2004


Did this article provide the answer you needed?
 
Yes
No
Not Sure
 
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.