Keil Logo

CAN Interface

The CAN Interface uses an TJA1040 CAN driver at IC12 on the MCB1800 board.

MCB1800 Board CAN Interface

The CAN DB9 connectors are wired so that Pin 2 provides the CANL signal and Pin 7 provides the CANH signal. These pins are connected to a TJA1040 CAN driver.

Jumper J19 and J20 incorporates a 120 ohm termination resistor between the CANL and CANH signals.

MCB1800 CAN DB9 Connector


  • CAN termination resistors make it easy to connect the MCB1800 board to your CAN network but they are not always required. When connecting the MCB1800 Board to a CAN network, you may need to remove jumpers 19 and J20.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.